POLYPLAN hose pump
Order No.: 1200S
for injection and filling with resin, foam and cement suspensions up to 0,2 mm graining
By developing highly flexible, pressure-resistant-hoses and constructing a 3-chamber system, pressures up to circa 15 bar can be reached with this pump while maintaining consistently good delivery. Because this pump can not be contaminated by resin etc. its applications are unrestricted. No more cleaning problems!
The pumped liquids will no longer come into contact with the pump mechanism. Upon completation of a work step, or when the pot life of the liquids is exceeded, just insert another hose within 3 minutes, and the pump will again be ready for operation. Operating pressure may reach up to circa 15 bar. The liquids to be pumped can be taken directly from their containers. Small containers will fit into the supporting basket. With free flow, the delivery can reach 200 l/h. (Viscosity and counterpressure will reduce the delivery rate.) The pump is of solid construction, entirely maintenance-free and unaffected by outside influences.
The hose-pump 1200 S is equipped with a coupling flanged to the reduction gearing and designed to take any commercial electronic drill with holding attachment for accessory equipment. The chuck must be detachable and the spanner flat behind it must be 17 mm. For the injection, use only low-pressure nipples, do not use high-pressure nipples!
On request we can supply an attachment for your drill to your specifications (drawing or sample) for an extra charge. An even working pressure and uniform delivery is ensured by the electronics of the drill. Please also note the various combinations available for the connection of hose and packers.
Scope of delivery:
Hose-pump 1200 S complete with hose connection, consisting of: nipple gripper 1042V, hand pipe 1042R, cock 1170, hose connector 1284 and clamp 1285 but without hose.
Weight without drill circa 3 kg.
Drive: Electric drill or compressed-air machine