Packer element 13 mm, stainless steel

Order no.: RV13P

Item description

TWO-PART COMPOSITE PACKERS as an alternative for injection packers

Both parts can be combined differently, in this way there is a variety of possible applications!
Suitable for low pressure and high pressure, due to a low opening pressure of circa 1-2 bar. The advantage is the saving of time as described below, as well as that the pressure elements can be used multiple.
Handling and pressing is the same as with the service-proven drill-hole packers. The decisive advantage: the pressure element (front part) can be removed after injection without any loss of pressure whatever, the drill hole can be closed off straight away. This means: less time and labour must be expended The pressure element, if cleaned out well, may be used again more than 5 times.
Lowering of the packer element is simple because of pressure elements being available in varying lengths.
The composite packer can be retightened (as opposed to the impact packing element), thus no interruption of the injection process. Another advantage is the fact that the composite packer can be subjected to much higher pressure than a packer with a pretermined breaking point.